MASCHINE 1.5 Reference Manual – 45
Adjusting the Settings from the Hardware
You also have access to these settings from the Hardware. To do this, you rst have to enter
the MIDI Mode by pressing SHIFT+CONTROL. From this MIDI Mode, press SHIFT+Button
4 to show the Settings Display Mode. In this Display Mode, the Left Display gives you access
to all of the settings described above, with the exception of the vEloCIty SCalInG. The Knobs
1-4 allow you to adjust the BrIGhtnESS, pad SEnSItIvIty, ContraSt lEFt and ContraSt rIGht, re-
spectively.
When you’re done, press SHIFT+CONTROL again to quit the MIDI Mode and get back to
the MASCHINE Mode.
2.5 Audio and MIDI Settings
►
To open the Audio and MIDI Settings dialog, select the Audio and MIDI Settings… entry
from the File menu.
2.5.1 Audio Tab
The Audio Tab of the Audio and MIDI Settings dialog
To Next Page
Loading...
