MASCHINE 1.5 Reference Manual – 128
7.2.7 Step Grid, Pattern Length Grid and Quantization
Step Grid
The Step Grid determines the quantization of the notes entered in the Pattern. It ranges from
1/1 (one full note) to 1/64T (1/64th note triplet) and can also be turned off. The default value
is 1/16th. Select the Step Grid by clicking the STEP label in the Edit Controls, at the bottom
left. This opens up a dropdown menu:
The dropdown menu of the Step Grid
Pattern Length Grid
In addition to the Step Grid there is the Pattern Length Grid which determines the increments
in which the Pattern Length can be resized (described below). Choose the Pattern Length
Grid by clicking on the lEn label, located in the Pattern Length Control at the top left:
To Next Page
Loading...
