CHAPTER 3 SYSTEM DATA PROGRAMMING
– 126 –
NWA-008855-001 Rev.1.0
avch3001.fm
DESCRIPTION DATA
Specify the DP Make Ratio. •
(1)
(2)
Y=25
00-63: Trunk Route No.
0 : 39 % Make Ratio
1 : 33 % Make Ratio
Assign the DTMF signal width to the trunk
route.
NOTE: To reduce the connecting time, it is
recommended to shorten the DTMF
inter-digital Pause timing (Y=24),
i.e., second data=2 (80 ms.). Y=26,
i.e., second data=0 (64 ms.).
•
(1)
(2)
Y=26
00-63: Trunk Route No.
0: 64 ms.
1 : 128 ms.
Assign the trunk release by detection of rever-
sal of tip and ring to the trunk route.
•
(1)
(2)
Y=39
00-63: Trunk Route No.
0 : Not released
1 : To release
CAUTION: Check the timing on main PBX before making any change on timing function.
Specify the DP Sender release timing to the
trunk route.
•
(1)
(2)
Y=45
00-63: Trunk Route No.
0 : 2 seconds
1 : 4 seconds
2 : 6 seconds
3 : 8 seconds
4 : 12 seconds
5 : 14 seconds
6 : 16 seconds
7 : 10 seconds
C
CM35
D
TRUNK DATA PROGRAMMING (For Adjunct Analog)
To Next Page
Loading...
