About this task
When attaching a cable chain, reverse the order you used when disconnecting the cable chain. You
must insert the chain's horizontal connector into the horizontal guide rail in the enclosure before
inserting the chain's vertical connector into the vertical guide rail in the enclosure.
Steps
1. From the back of the drive shelf, remove the fan canister on the right side, and set it aside.
2. If the shelf is powered on, ensure that the left fan goes to its maximum speed.
Attention: Possible equipment damage due to overheating – If the shelf is powered on, do
not remove both fans at the same time. Otherwise, the equipment might overheat.
3.
Attach the right cable chain:
a. Locate the horizontal and vertical connectors on the right cable chain and the corresponding
horizontal guide rail and vertical guide rail inside the enclosure.
b. Align both cable chain connectors with their corresponding guide rails.
c. Slide the cable chain's horizontal connector onto the horizontal guide rail, and push it in as far
as it can go.
Attention: Risk of equipment malfunction — Make sure to slide the connector into the
guide rail. If the connector rests on the top of the guide rail, problems might occur when the
system runs.
The figure shows the horizontal and vertical guide rails for the second drive drawer in the
enclosure.
Drives |
75
To Next Page
Loading...
