Configure Quality of Service
180
S350 Series 8-Port Gigabit Ethernet Smart Managed Pro Switch Models GS308T and GS310TP
Note the following about the DiffServ process:
• Packets are filtered and processed based on defined criteria. The filtering criteria is
defined by a class. The processing is defined by a policy's attributes. Policy attributes can
be defined on a per-class instance basis, and it is these attributes that are applied when a
match occurs.
• The configuration process begins with defining one or more match criteria for a class.
Then one or more classes are added to a policy. Policies are then added to interfaces.
• Packet processing begins by testing the match criteria for a packet. The All class type
option specifies that each match criteria within a class must evaluate to true for a packet
to match that class. The Any class type option specifies that at least one match criteria
must evaluate to true for a packet to match that class. Classes are tested in the order in
which they were added to the policy. A policy is applied to a packet when a class match
within that policy is found.
Configure and Display Global DiffServ Settings
You can display DiffServ general status group information, which includes the current
administrative mode setting as well as the current and maximum number of rows in each of
the main DiffServ private MIB tables.
 To configure the global DiffServ mode and display DiffServ general status group
information:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 11.
Your web browser might display a security message, which you can ignore. For more
information, see
Access the Local Browser Interface on page 19.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select QoS > DiffServ > Advanced > DiffServ Configuration.
To Next Page
Loading...
Need help?
General
