Configure System Information
95
S350 Series 8-Port Gigabit Ethernet Smart Managed Pro Switch Models GS308T and GS310TP
5. Select Systemï€ > Services > DHCP Snooping > Statistics.
The DHCP Snooping Statistics page displays.
6. Click the Clear button to clear all interfaces statistics.
The following table describes the DHCP snooping statistics.
Table 19. DHCP Snooping Statistics information
Field Description
Interface The interface associated with the rest of the data in the row.
MAC Verify Failures The number of DHCP messages that were dropped because the source MAC address
and client hardware address did not match. MAC address verification is performed only if
it is globally enabled.
Client Ifc Mismatch The number of packets that were dropped by DHCP snooping because the interface and
VLAN on which the packet was received do not match the client’
s interface and VLAN
information stored in the binding database.
DHCP Server Msgs
Received
The number of DHCP server messages (such as DHCPOFFER, DHCPACK, DHCPNAK,
and DHCPRELEASEQUER
Y messages) that were dropped on an untrusted port.
Set Up PoE Timer Schedules
The switch lets you define multiple timer schedules (each with a unique name) that you can
use for PoE power delivery to attached PDs.
After you create a timer schedule, you can associate it with one or more PoE ports (see
Configure the PoE Port Settings on page 65). You can use a separate timer schedule for
each PoE port.
After you associate a timer schedule with a PoE port, the start date and time force the PoE
port to stop delivering power and the stop date and time enable the PoE port to start
delivering power
.
You can create absolute timer schedules, which apply to specific dates and times, and you
can create recurring timer schedules. For each timer schedule, you can add multiple entries
that apply to the selected timer schedule only
.
Create a PoE Timer Schedule
The maximum number of timer schedules that you can add is 100.
 To create a PoE timer schedule:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is of
f-network using an Ethernet cable.
2. Launch a web browser.
To Next Page
Loading...
Need help?
General
