NETGEAR GS728TS - Page 176

176
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
To manage the ARP entries:
1. To move certain type of entries, select the type of entries to remove from the Remove
From Table menu. The choices listed specify the type of ARP Entry to be deleted:
• All Dynamic Entries
• All Dynamic and Gateway Entries
• Specific Dynamic / Gateway Entry. Selecting this allows you to specify the required
IP address.
• Specific Static Entry.
• None. Select if you do not want to delete any entry from the ARP Table.
2. If you select Specific Dynamic/Gateway Entry or Specific Static Entry in the Remove
from Table list, you can enter the IP address of an entry to remove from the ARP table.
3. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
4. If you change any of the settings on the page, click Apply to send the updated configuration
to the switch.