194
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
• Conform Action. Determines what happens to packets that are considered
conforming (below the police rate). Select one of the following actions:
• Send. (default) These packets are presented unmodified by DiffServ to the
system forwarding element.
• Drop. These packets are immediately dropped.
• Mark CoS. These packets are marked by DiffServ with the specified CoS value
before being presented to the system forwarding element. This selection requires
that the Mark CoS value field be set.
• Mark IP Precedence. These packets are marked by DiffServ with the specified IP
Precedence value before being presented to the system forwarding element. This
selection requires that the Mark IP Precedence value field be set.
• Mark IP DSCP. These packets are marked by DiffServ with the specified DSCP
value before being presented to the system forwarding element. This selection
requires that the DSCP value field be set.
• Violate Action. Determines what happens to packets that are considered
non-conforming (above the police rate). Select one of the following actions:
• Send. (default) These packets are presented unmodified by DiffServ to the
system forwarding element.
• Drop. (default) These packets are immediately dropped.
• Mark CoS. These packets are marked by DiffServ with the specified CoS value
before being presented to the system forwarding element. This selection requires
that the Mark CoS value field be set.
• Mark IP Precedence. These packets are marked by DiffServ with the specified IP
Precedence value before being presented to the system forwarding element. This
selection requires that the Mark IP Precedence value field be set.
• Mark IP DSCP. These packets are marked by DiffServ with the specified DSCP
value before being presented to the system forwarding element. This selection
requires that the DSCP value field be set.
5. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
6. If you change any of the settings on the page, click Apply to send the updated configuration
to the switch. Configuration changes take effect immediately.
7. Click Refresh to refresh the page with the most current data from the switch.
To Next Page
Loading...
Need help?
General