NETGEAR GS728TS - Page 205

205
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
The TACACS+ protocol ensures network security through encrypted protocol exchanges
between the device and TACACS+ server.
The TACACS+ folder contains links to the following features:
• Configuring TACACS+ on page 204
• TACACS+ Server Configuration on page 206
TACACS+ Configuration
The TACACS+ Configuration page contains the TACACS+ settings for communication
between the switch and the TACACS+ server you configure via the inband management port.
To display the TACACS+ Configuration page, click Security > Management Security, and
then click the TACACS+ > TACACS+ Configuration link.
To configure global TACACS+ settings:
1. In the Key String field, specify the authentication and encryption key for TACACS+
communications between the GS728TS, GS728TPS, GS752TS, or GS752TPS and the
TACACS+ server. The valid range is 0–128 characters. The key must match the key
configured on the TACACS+ server.
2. In the Connection Timeout field, specify the maximum number of seconds allowed to
establish a TCP connection between the GS728TS, GS728TPS, GS752TS, or GS752TPS
and the TACACS+ server. The valid range is 1–30 seconds.
3. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
4. If you make any changes to the page, click Apply to apply the new settings to the system.