46
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
To access the Auto-DoS Configuration page, click System > Management > Denial of Service
> Auto-DoS Configuration.
To configure the Auto-DoS feature:
1. Select a radio button to enable or disable Auto-DoS:
• Disable. Auto-DoS is disabled (default).
• Enable. Auto-DoS is enabled.
2. Click Apply to send the updated configuration to the switch. Configuration changes occur
immediately.
3. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
To Next Page
Loading...
