NETGEAR GS728TS - Page 67

67
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches
To configure the mode of the stack ports:
1. Select the check box associated with the unit and port to configure:
2. From the Configured Stack Mode field, select the operating mode:
• Stack. The port connects to the stack port on another stack member. This is the
default value.
• Ethernet. The port operates as a standard switch port that receives and transmits
network traffic
3. Click Apply to apply the new settings to the system.
4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
5. Click Refresh to update the screen with the current information.
The following table describes Stack Port Configuration fields.
Field Description
Unit ID Displays the unit.
Port Displays the stackable interfaces on the given unit.
Running Stack Mode Displays the run-time mode of the stackable interface.
Link Status Displays the link status (UP/DOWN) of the port.
Link Speed (Gbps) Displays the maximum speed of the stacking port.
Transmit Data Rate (Mbps) Displays the approximate transmit rate on the stacking port.
Transmit Error Rate Displays the number of errors in transmit packets per second.
Total Transmit Errors Displays the total number of errors in transmit packets since boot. The
counter may wrap.
Data Rate (Mbps) Displays the approximate receive rate on the stacking port.
Receive Error Rate Displays the number of errors in receive packets per second.
Total Receive Errors Displays the total number of errors in receive packets since boot. The
counter may wrap.