NetWave NW6000 - Page 134

Page 134/ 191
Please pay attention to the configuration of the Global Navigation Satellite System (GNSS).
During installation it is required that position of the antenna will be registered by location on
the vessel in General Settings. In the additional notes field please add the required z –
coordinate (measured from high water line).
Additional VDR critical sensors are configured in Critical Settings…
Further, the system can
and will accept
Glonass/GPS (“GN”)
and Glonass (“GL”)
receiver messages, to
be filled at the Talker
ID.
Once all pages have been filled,
save the configuration to the VDR.