EDH0162En1040 – 06/99 3.54
MM4005 FC — Clear function key line
Usage IMM PGM MIP
Syntax FC
Parameters
None.
Description This command clears the function key line displayed by the FD or WF com-
mands. It is intended to be used in conjunction with the FB, FD and WF
commands to build front panel interactive programs.
NOTE
The command is valid only in programming mode, applying only to the
custom-defined function keys, not the ones used by the normal operation
of the controller.
Returns
None.
Errors A — Unknown message code.
J — Command authorized only in programming mode.
Rel. Commands FB — Label function key.
FD — Display function keys.
WF — Wait for function key.
Example 3XX | Clear program #3 from memory, if any.
3EP | Activate program mode and enter following commands as program
#3.
4FBSTOP | Define custom label for function key #4 as STOP.
… |
… |
… |
7WF |
Display the custom function key label(s) (STOP), wait for a valid
function key to be pressed and put its ASCII code in variable #7.
FC | Clear function key display line.
… |
… |
… |
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
