3.81 EDH0162En1040 – 06/99
MM4005 NE — Set trajectory element
where the generation of pulses ends
Usage IMM PGM MIP
Syntax NEnn or NE?
Parameters
Description nn
[int] — Number of trajectory element where the pulses genera-
tion ends.
? — Read the number of trajectory element where the puls-
es generation ends.
Range nn — 1 to 100.
Units nn
— None.
Defaults nn Missing: 1.
Out of range: Error C.
Description This command sets number of trajectory element where the generation of
pulses ends. The generation of pulses is ended immediately in the end of
this element.
NOTE
As the total element number of a trajectory may be inferior than 100 and
the value of NB must be ≤ the value of NE ≤ the total element number,
this value of NE will be reexamined in NS and ET commands.
Returns
If the sign “?” takes place of the nn value, this command reportes the num-
ber of trajectory element where the generation of pulses ends.
Errors A — Unknown message code.
B — Incorrect axis number.
C — Parameter out of limits.
D — Unauthorized execution.
Rel. Commands NB —
Set trajectory element where the generation of pulses starts.
NI — Set step (curvi-linear distance) between synchronisation pulses.
NN — Set number of synchronisation pulses to generate.
Example NE4 | Generation of pulses ends at the end of the element #4.
NE? | Read element number where the generation of pulses ends.
NE4 | Controller tells the value.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
