To open or close the Classic view in Plug-in mode:
▶ Press SHIFT + Button 5 (Classic View) to open or close the Classic view.
When you close the Classic view, the display switches back to the default Performance view.
Switching Parameter Pages
Most products are equipped with much more than eight parameters. To provide quick access to
additional parameters, the Page buttons (left and right arrows) at the left of the display let you
skip through parameter pages. This remaps the knobs below the display to a different set of
parameters.
To select another page:
▶ Press the Page buttons at the left of the display to switch to another page of parameters.
→ The display and the Knobs 1–8 switch to the next or previous eight parameters.
A dim lit Page button indicates that another page can be displayed by pressing the button.
The gray numbers at the far right on the display indicate the current page and the total number of
pages available:
Within a page, parameters are often organized into sections, for example according to the
submodule they belong to. The section names show up above the parameter names on the
display.
Custom Parameter Mappings
The Classic view shows you the custom parameter mappings that you might have created and
saved with your user presets in the Komplete Kontrol software. For more information on how to
create custom parameter mappings, refer to the Komplete Kontrol software manual.
Custom parameter mappings are only available when your keyboard is connected to
the Komplete Kontrol software.
CONT R O L LING INSTRUMENT S A N D EFFECTS 33
To Next Page
Loading...
Need help?
General