Other Octaves
The rst OTHER parameter, Octaves, is only available in Arp mode. It lets you decide the range
of the arpeggiator sequence. You can choose to play back your sequence within the octave of
only the keys you pressed on the keyboard, or you can select up to eight octaves and let the
corresponding notes of your chord or scale be played back in as many octaves.
Depending on the settings you have made to the Type parameter, the octaves played back can be
above (e.g., Up), below (e.g., Down) or both above and below (Up & Down) the pressed keys.
The Octaves setting includes the following values:
• 1, 2, 3, 4, 5, 6, 7, 8
Other Dynamic
The second OTHER parameter, Dynamic, is only available in Arp mode. It reads the velocity of the
input (a key you pressed on the keyboard or an incoming MIDI note from the DAW) and scales it
by the factor you set with the Dynamic parameter. The scaling is applied per note. The velocity of
each played note is taken and multiplied by the value set with the Dynamic parameter.
Dynamic lets you set a value between 1.0% and 200.0%.
Other Gate
The third OTHER parameter, Gate, is available in both Arp and Note Repeat mode. It lets you
decide the length of the notes in your sequence. Setting a value between 1% and 99% makes the
duration of the notes shorter than they otherwise would be. Setting a value between 101% and
200% instead elongates the duration of the notes.
Gate lets you set a value between 1.0 % and 200.0 %.
Gate Reset
The Gate Reset function, mapped to Button 4 above the display, lets you reset the Gate parameter
to its default value of 100 % at any time.
The Gate Reset function.
Advanced Parameters
The ADVANCED parameters Retrigger, Repeat, Offset, and Inversion allow you to explore
alternative versions of the same arpeggiator sequence.
ARPE G G I ATOR 68
To Next Page
Loading...
Need help?
General