The ADVANCED parameters Retrigger, Repeat, Offset, and Inversion on page 2.
Advanced Retrigger
The rst ADVANCED parameter, Retrigger, is only available in Arp mode. Retrigger sets a number
of steps in the arpeggiator sequence after which the sequence restarts its cycle, regardless of the
number of pitches in the sequence.
For example:
• If the arpeggiator sequence consists of a 5 note cycle (1 - 2 - 3 - 4 - 5) and Retrigger is set to 3,
the Arpeggiator output is 1 - 2 - 3 - repeat.
• If the arpeggiator sequence consists of a 5 note cycle (1 - 2 - 3 - 4 - 5) and Retrigger is set to 8,
the Arpeggiator output is 1 - 2 - 3 - 4 - 5 - 1 - 2 - 3 - repeat.
Rests in a Sequence are treated as steps:
• If the arpeggiator sequence consists of 6 pitches, the Sequence is 1 - 2 - 3 - rest - 4 - 5 - 6 –
rest, and Retrigger is set to 5, the Arpeggiator output is 1 - 2 - 3 - rest - 4 -repeat.
Advanced Repeat
The second ADVANCED parameter, Repeat, is only available in Arp mode. Repeat sets a number
by which each step in the arpeggiator sequence is repeated.
For example:
• If the arpeggiator sequence consists of a 3 note cycle (1 - 2 - 3) and Repeat is set to 3, the
Arpeggiator output is 1 - 1 - 1 - 2 - 2 - 2 - 3 - 3 - 3 - repeat.
Advanced Offset
The third ADVANCED parameter, Offset, is only available in Arp mode. Offset sets a number by
which the steps in the arpeggiator sequence are shifted in the cycle.
For example:
• If the arpeggiator sequence consists of a 5 note cycle (1 - 2 - 3 - 4 - 5) and Offset is set to 0, the
Arpeggiator output is 1 - 2 - 3 - 4 - 5 - repeat.
• If the arpeggiator sequence consists of a 5 note cycle (1 - 2 - 3 - 4 - 5) and Offset is set to +1,
the Arpeggiator output is 2 - 3 - 4 - 5 - 1 - repeat.
• If the arpeggiator sequence consists of a 5 note cycle (1 - 2 - 3 - 4 - 5) and Offset is set to -1,
the Arpeggiator output is 5 - 1 - 2 - 3 - 4 - repeat.
ARPE G G I ATOR 69