EasyManuals Logo

NI KONTROL S Series User Manual

Default Icon
89 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #86 background imageLoading...
Page #86 background image
ASSIGN TIP (page 2) / ASSIGN RING (page 3):
Type: Selects the type of MIDI message used. Available values are CntrlChg (Control
Change), Ptchbnd (Pitchbend) and PrgrmChg (Program Change). The following settings
will vary depending on the type selected here.
MIDI:
Channel: Selects the MIDI channel used.
Number: Selects the Control Change number (from 0 to 127). This setting is only available
when the Type (Knob 1 on the same page) is set to CntrlChg (Control Change).
Mode: Selects the behavior of the pedal between Toggle, Gate, Trigger, and Incr
(Increment). This setting is only available if the Type setting (Knob 1 on the same page) is
set to CntrlChg (Control Change) or PrgrmChg (Program Change). The various MIDI modes
behave as follows:
Toggle: The pedal can have two values. Each pressure on the pedal switches to the
other value.
Gate: The pedal can have two values. One value corresponds to the released pedal, the
other value corresponds to the depressed pedal.
Trigger: The pedal triggers a specic value when depressed. Releasing the pedal has no
effect.
Incr (Increment): Each pressure on the pedal increments the controller parameter by a
dened value.
Value: Sets the value of the MIDI message triggered when pressing the pedal. This setting is
only available if the MIDI Mode (Knob 4 on the same page) is set to Trigger.
VALUE: These settings are only available if the MIDI Mode (Knob 4 on the same page) is set to
Toggle or Gate.
Off: In Toggle mode, this sets the rst of two alternative MIDI values sent when pressing the
pedal. In Gate mode, this sets the value sent when the pedal is released.
On: In Toggle mode, this sets the second of two alternative MIDI values sent when pressing
the pedal. In Gate mode, this sets the value sent when the pedal is pressed.
RANGE: These settings are only available if the MIDI Mode (Knob 4 on the same page) is set to
Incr (Increment).
Min: Sets the minimum value of the MIDI message sent by the pedal.
Max: Sets the maximum value of the MIDI message sent by the pedal.
Step: Sets the size of the increment added to the MIDI message value for each pressure on
the pedal. You can set a negative increment, in which case the value will decrease on each
pressure on the pedal.
Wrap: If set to Off, when the range limit is reached the value will stop changing when you
further press the pedal. If set to On, when the range limit is reached the value will cycle the
range upon the next pressure.
Touch Strip Settings
The touch strip settings let you congure the behavior of the touch strip on your keyboard.
KEYB O A R D SETTINGS 82

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NI KONTROL S Series and is the answer not in the manual?

NI KONTROL S Series Specifications

General IconGeneral
BrandNI
ModelKONTROL S Series
CategoryDJ Equipment
LanguageEnglish