• ASSIGN:
• Type: Selects the type of MIDI message used. Available values are Control Change,
Pitchbend and Program Change. The following settings will vary depending on the type
selected here.
• MIDI:
• Channel: Selects the MIDI channel used.
• Number: Selects the Control Change number (from 0 to 127). This setting is only available
when the Type (Knob 1 on the same page) is set to Control Change.
• RANGE: These settings are only available for the Modulation wheel (page 2) and if the Type
(Knob 1 on the same page) is set to Control Change or Program Change.
• From: Selects the minimum value of the MIDI control range.
• To: Selects the maximum value of the MIDI control range.
General Information
The General display provides you with general information on your keyboard and lets you reset
your device to factory defaults.
The following information are available:
• The model of your keyboard is displayed in the bottom left corner above Knob 1 (ABOUT).
• In the right part of the display, you can see the serial number of your device, some additional
software component information, as well as credits for the people that made this product
happen. You can use Knob 8 to scroll these information.
Resetting Your Device to Factory Settings
From the General display you can reset your keyboard to its factory state. To do this:
1. Press Button 8 (Reset Unit) to start the reset procedure.
→ A warning message asks you to conrm the operation.
2. Press Button 8 (OK) to conrm the reset, or Button 7 (Cancel) to cancel the procedure.
→ Upon your conrmation, all settings of your keyboard are reset to their factory default values.
KEYB O A R D SETTINGS 84
To Next Page
Loading...
Need help?
General