Nikon COOLSCAN V ED - Assembly Procedures; LED and AF unit assembly

VRA53801 - R.3609.A
- A
1・
LS-50 -
Assembly
1. LED block unit
・Attach the LED block unit (2) on the illuminate base assembly (1).
・Put the LED block unit (2) in place by pressing in the direction of ( )and fix it with 2 screws (3).
・While avoiding the twisting of the harness passed through ( ) of LED block unit (2), put it in through
( 〇 ) part of the illuminate base assembly (1) to be pinched.
2. AF unit
・Attach the AF unit (2) on the scan block unit (1).
・Fold the FPC of the AF unit (2) along each ( ) line (of 2 parts).
・Fix the motor unit of the AF unit (2) with 2 screws (3).
・Check if there is no dust attached on the sensor of ( 〇 ) part.
・Put the inner sensor of ( 〇 ) part into the hole of scan block unit (1).
・Fix the AF-FPC unit of the AF unit (2) with the screw (4).
①
②
③
Fold here
①
③
②
④