NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M140 Tow Tractor Manual No. 46054
PAGE 3-11
CHAPTER 2 MAINTENANCE
3 REMOVAL AND INSTALLATION
AUGUST 31, 2008
3.
it in place.
4. Remove converter drain plug access cover from lower end of converter
housing. torque converter with drive plate (for easier installation).
5.
pulley attaching bolt to turn converter to gain access to bump switch.
6. With wrench on crankshaft pulley attaching bolt, turn converter to gain access
7. Disconnect park brake cable. Disconnect from transmission park brake disk
and slide shaft rearward from transmission. Install a seal installation tool in
8. Disconnect downshift and manual linkage rods or cable controls from levers at
transmission.
9. Disconnect oil cooler lines from transmission. Disconnect temperature sender
wire.
10. Remove vacuum hose from vacuum diaphragm unit. Remove vacuum line from
retaining clip.
11. Disconnect cable from terminal on starter motor. Remove the three attaching
bolts and remove starter motor.
12. Remove transmission rear support and insulator assembly attaching bolts at
bottom rear of transmission.
13.
14. Remove bolts securing transmission to frame and remove cross member.
15. Secure transmission to jack with safety chain.
16. Remove converter housing-to-engine attaching bolts.
17. Move transmission away from engine.
NOTICE!
of the transmission must be allowed to rest on the drive plate during removal or
installation.
18. Lower transmission jack and move transmission and converter assembly from
under vehicle.
To Next Page
Loading...
