NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M140 Tow Tractor Manual No. 46054
PAGE 1-22
CHAPTER 2 MAINTENANCE
1 SERVICING
AUGUST 31, 2008
21. Install front wheels and tighten mounting nuts to 90 ft-lbs torque.
22. Remove jack stands and jack.
After initially mounting wheel and tire assembly, recheck lug
operation. After this, check monthly or every 250 hours, whichever comes
Failure to follow these procedures could result in wheel mounting failure and
loss of vehicle control.
1.6.3 Transmission - C-6
(For Allison Transmission Service, See 1.8.4)
Fluid Level and Condition
1. Bring transmission to normal operating temperature (about 180º F). Five
minutes of driving, including frequent stops and starts, will usually produce
2. Set gear selector to neutral (N) and withdraw transmission dipstick
(located in engine compartment on driver’s right) to check oil level.
NOTICE!
small amounts and recheck level frequently.
3.
smell. This would indicate damaged bands or clutches. If oil has a milky
look, water has entered the transmission. Air bubbles mean there is an air
leak in the suction lines. Report any of these conditions to your supervisor.
4.
between “FULL” and “ADD 1 PINT” marks on the dipstick. See 1.3, Fluids
And Capacities.
Transmission Service - C6
The Ford C6 transmission combines a torque converter with a two-speed or
three-speed, fully automatic unit for transmitting engine torque to the drive
the recommended service intervals and adjusting the linkage, intermediate
band and the neutral start switch.
Removal and installation procedures are included in the event the
transmission must be replaced or sent to a specialized repair facility.
To Next Page
Loading...
