Basic System Configuration Guide Boot Options
Edition: 01 3HE 11010 AAAC TQZZA 131
For the 7705 SAR-M, there are two options:
• remove the compact flash, connect it to a PC, and download another software
package from OLCS; contact your Nokia support representative for detailed
instructions
• return the faulty chassis to Nokia for replacement
For the 7705 SAR-H, there are one or two options:
• if the compact flash is accessible, connect it to a PC, and download another
software package from OLCS; contact your Nokia support representative for
detailed instructions
• return the faulty chassis to Nokia for replacement
For the 7705 SAR-A, 7705 SAR-Ax, 7705 SAR-Hc, 7705 SAR-W, 7705 SAR-Wx,
and 7705 SAR-X, return the faulty chassis to Nokia for replacement.
When the bootstrap image is loaded, the BOF is read to obtain the location of the
image and configuration files. The BOF should be located on the same compact flash
drive as the boot.ldr file. If the BOF cannot be found or loaded, the system prompts
the user for alternate software and configuration file locations.
The following example displays the output when the boot sequence is interrupted.
. . .
Hit a key within 3 seconds to change boot parms...
You must supply some required Boot Options. At any prompt, you can type:
"restart" - restart the query mode.
"reboot" - reboot.
"exit" - boot with existing values.
Press ENTER to begin, or 'flash' to enter firmware update...
Software Location
-----------------
You must enter the URL of the TiMOS software.
The location can be on a Compact Flash device,
or on the network.
Here are some examples
cf3:/timos2.0R1
ftp://user:passwd@192.168.xx.xxx/./timos2.0R1
tftp://192.168.xx.xxx/./timos2.0R1
The existing Image URL is 'ftp://*.*@192.168.xx.xxx/./rel/0.0/xx'
Press ENTER to keep it.
Software Image URL:
Using: 'ftp://*.*@192.168.xx.xxx/./rel/0.0/xx'
Configuration File Location
---------------------------
To Next Page
Loading...
