CLI Usage
96
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
3.9.2.4 Rollback Commands
rollback
Syntax rollback
Context admin
config>system
Description This command enables the context to configure rollback command parameters.
Default n/a
compare
Syntax compare [to checkpoint2]
compare checkpoint1 to checkpoint2
Context admin>rollback
Description The compare command with no parameters defined, compares the active configuration to the
most recent rollback file. The compare command with the checkpoint2 parameter defined
compares the active configuration to the specified file. The compare command with both
checkpoint parameters defined compares one specified file to another specified file
A compare operation does not check authorization of each line of output. Permission to
execute the compare command should only be given to users who are allowed to view the
entire system configuration.
Default checkpoint1 — active-cfg
checkpoint2 — latest-rb
Parameters checkpoint1, checkpoint2 — the configuration files to use as comparison sources
Values
active-cfg the active operational system configuration
rescue the rollback rescue file from the configured rescue
location
latest-rb the most recent rollback checkpoint file from the
configured rollback location, with the suffix *.rb
checkpoint-id The ID value of a specific rollback checkpoint file from
the configured rollback location with the suffix *.rb.x.
The default is 1 to 9 but the maximum value depends
on the local-max-checkpoints and remote-max-
checkpoints configurations.
To Next Page
Loading...
