Basic System Configuration Guide CLI Usage
Edition: 01 3HE 11010 AAAC TQZZA 99
view
Syntax view [checkpoint-rescue]
Context admin>rollback
Description This command displays the configuration settings saved in a rollback checkpoint or rescue
file, or the active operational system configuration.
Default latest-rb
Parameters checkpoint-rescue — identifies the configuration file to view
Values
local-max-checkpoints
Syntax local-max-checkpoints [number]
no local-max-checkpoints
Context config>system>rollback
Description This command configures the maximum number of rollback checkpoint files that can be
saved to the local compact flash.
When the maximum number of files are saved, the oldest rollback checkpoint file will actually
have an ID value one less than the configured maximum, because one rollback checkpoint
file is always the latest file and does not have an ID number. For example, if you configure
the maximum number of checkpoints as 50, after performing 50 rollback save commands,
there will be a latest rollback checkpoint file with extension *.rb, and 49 older files with
extension *.rb.1 to *.rb.49.
The no form of this command resets the maximum value to the default.
Default 10
Parameters number — the maximum number of rollback checkpoint files
Values 1 to 50
rescue the rollback rescue file from the configured rescue
location
latest-rb the most recent rollback checkpoint file from the
configured rollback location, with the suffix *.rb
checkpoint-id The ID value of a specific rollback checkpoint file
from the configured rollback location with the suffix
*.rb.x.
The default is 1 to 9 but the maximum value depends
on the local-max-checkpoints and remote-max-
checkpoints configurations.
To Next Page
Loading...
