Boot Options
162
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
5.11 Configuring BOF Parameters
Use the CLI syntax displayed below to configure BOF components:
CLI Syntax: bof
address ip-prefix/ip-prefix-length [active |
standby]
autonegotiate
auto-discover
console-speed baud-rate
dns-domain dns-name
duplex {full | half}
fips-140-2
persist {on | off}
primary-config file-url
primary-dns ip-address
primary-image file-url
save [cflash-id]
secondary-config file-url
secondary-dns ip-address
secondary-image file-url
speed speed
static-route ip-prefix/ip-prefix-length next-hop
ip-address
tertiary-config file-url
tertiary-dns ip-address
tertiary-image file-url
wait seconds
The following example displays BOF command usage:
Example: ALU-1# bof
ALU-1>bof# address 10.10.10.103/20 active
ALU-1>bof# dns-domain ca.alcatel.com
ALU-1>bof# duplex full
ALU-1>bof# fips-140-2
ALU-1>bof# persist on
ALU-1>bof# wait 3
ALU-1>bof# primary-image cf3:\TIMOS.5.0.R0
ALU-1>bof# primary-config cf3:\test123.cfg
ALU-1>bof# primary-dns 10.10.10.103
ALU-1>bof# save cf3:
A:ALU-1# show bof
===============================================================================
BOF (Memory)
===============================================================================
primary-image ftp://*:*@xxx.xxx.xxx.xx/home/csahwreg17/images/both.tim