Basic System Configuration Guide System Management
Edition: 01 3HE 11010 AAAC TQZZA 301
Cfg-OK Script Status : not used
Cfg-Fail Script : N/A
Cfg-Fail Script Status : not used
Management IP Addr : 192.168.1.202/24
DNS Server :
192.168.x.x
DNS Domain :
domain.com
BOF Static Routes :
To Next Hop
192.168.0.0/16 192.168.1.1
ATM Location ID : 01:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00
ATM OAM Retry Up : 2
ATM OAM Retry Down : 4
ATM OAM Loopback Period: 10
ICMP Vendor Enhancement: Disabled
===============================================================================
A:ALU-1#
When executing a post-boot configuration extension file, status messages are output
to the console screen prior to the “Login” prompt.
The following is an example of a failed boot-up configuration that caused a boot-bad-
exec file containing another error to be executed:
Attempting to exec configuration file:
’ftp://test:test@192.168.xx.xxx/./12.cfg’ ...
System Configuration
Log Configuration
MAJOR: CLI #1009 An error occurred while processing a CLI command -
File ftp://test:test@192.168.xx.xxx/./12.cfg, Line 195: Command "log" failed.
CRITICAL: CLI #1002 An error occurred while processing the configuration file.
The system configuration is missing or incomplete.
MAJOR: CLI #1008 The SNMP daemon is disabled.
If desired, enable SNMP with the ’config>system>snmp no shutdown’ command.
Attempting to exec configuration failure extension file:
’ftp://test:test@192.168.xx.xxx/./fail.cfg’ ...
Config fail extension
Enabling SNMP daemon
MAJOR: CLI #1009 An error occurred while processing a CLI command -
File ftp://test:test@192.168.xx.xxx/./fail.cfg, Line 5: Command "abc log" failed.
TiMOS-B-5.0.R3 both/hops Nokia 7705 SAR Copyright (c) 2016 Nokia.
All rights reserved. All use subject to applicable license agreements.
Built on Wed Feb 18 12:45:00 EST 2016 by builder in /rel5.0/b1/R3/panos/main
6.10.6 System Timing
If network timing is required for the synchronous interfaces in a 7705 SAR, a timing
subsystem is used to provide a Stratum 3 quality clock to all synchronous interfaces
within the system. The clock source is specified in the config>port>tdm>ds1 | e1>
clock-source context.
To Next Page
Loading...
