System Management
294
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
6.10.4 Configuring Backup Copies
The config-backup command allows you to specify the maximum number of backup
versions of configuration and index files kept in the primary location.
For example, if the config-backup count is set to 5 and the configuration file is called
xyz.cfg, the file xyz.cfg is saved with a .1 extension when the save command is
executed. Each subsequent config-backup command increments the numeric
extension until the maximum count is reached. The oldest file (5) is deleted as more
recent files are saved.
• xyz.cfg
• xyz.cfg.1
• xyz.cfg.2
• xyz.cfg.3
• xyz.cfg.4
• xyz.cfg.5
• xyz.ndx
Each persistent index file is updated at the same time as the associated configuration
file. When the index file is updated, then the save is performed to xyz.cfg and the
index file is created as xyz.ndx. Synchronization between the active and standby
CSMs is performed for all configurations and their associated persistent index files.
CLI Syntax: config>system
config-backup count
Example: config>system#
config>system# config-backup 7
The following example shows the config-backup configuration.
ALU-1>config>system> info
#------------------------------------------
echo "System Configuration"
#------------------------------------------
name "ALU-1"
contact "Fred Information Technology"
location "Bldg.1-floor 2-Room 201"
clli-code "abcdefg1234"
coordinates "N 45 58 23, W 34 56 12"
config-backup 7
...
----------------------------------------------
ALU-1>config>system>
To Next Page
Loading...
