Nokia 7705 - 3.23.5 Configuring Adjacency SID Parameters

Basic System Configuration Guide Boot Options
Edition: 01 3HE 11010 AAAC TQZZA 151
Figure 9 7705 SAR Console Port
To establish a console connection:
Step 1. Connect the terminal to the Console port on the front panel (Figure 9) using
the serial cable.
Step 2. Power on the terminal.
Step 3. Establish the connection by pressing the <Enter> key a few times on your
terminal keyboard.
Step 4. At the router prompt, enter the login and password.
The default login is admin.
The default password is admin.
5.4.2 Telnet Connection
Telnet access via a connection to the Management port provides the same options
for user and administrator access as those available through the Console port or
SSH. You can access the chassis with a Telnet connection from a PC or workstation
connected to the network once the following conditions are met:
• the chassis has successfully initialized
• Telnet connections have been enabled using the
config>system>security>telnet-server (or telnet6-server) command
• the Management port has been configured using the bof>address command as
shown below.
CLI Syntax: bof
address ip-prefix/ip-prefix-length [active |
standby]
where:
address is an IPv4 (or IPv6) address
7705 SAR-A
Mgmt
ToD Out
Lnk Act
Sync In
+Batt A
-Batt A
+Batt B
-Batt B
Console
812111097654B3B2B1B1A
Status
2A 3A 4A
ActLnk ActLnk ActLnk ActLnk
Stat Stat Stat Stat
2468
1357
Lnk Act Lnk Act Lnk Act Lnk Act
Stat Stat Stat Stat
T1/E1Ethernet
-48 VDC
23319
Console port