Nokia 7705 - 6.10.5.7 Post-Boot Configuration Extension Files

Basic System Configuration Guide System Management
Edition: 01 3HE 11010 AAAC TQZZA 299
If synchronization fails, the standby does not reboot automatically. The show
redundancy synchronization command displays synchronization output
information.
6.10.5.7 Post-Boot Configuration Extension Files
Two post-boot configuration extension files are supported and are triggered when
either a successful or failed boot configuration file is processed. The commands
specify URLs for the CLI scripts to be run following the completion of the boot-up
configuration. A URL must be specified or no action is taken. The commands are
persistent between router (re)boots and are included in the configuration saves
(admin>save).
CLI Syntax: config>system
boot-bad-exec file-url
boot-good-exec file-url
Example: config>system# boot-bad-exec ftp://t:t@192.168.xx.xxx/./
fail.cfg
config>system# boot-good-exec
ftp://test:test@192.168.xx.xxx/./
ok.cfg
The following example displays the command output:
ALU-1>config>system# info
#------------------------------------------
echo "System Configuration"
#------------------------------------------
name "ALU-1"
contact "Fred Information Technology"
location "Bldg.1-floor 2-Room 201"
clli-code "abcdefg1234"
coordinates "N 45 58 23, W 34 56 12"
config-backup 7
boot-good-exec "ftp://test:test@192.168.xx.xxx/./ok.cfg"
boot-bad-exec "ftp://test:test@192.168.xx.xxx/./fail.cfg"
sync-if-timing
begin
ref-order ref1 ref2 bits
..
----------------------------------------------
ALU-1>config>system#