System Management
296
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
ALU-1>admin# disconnect
ALU-1>admin# Logged out by the administrator
Connection to host lost.
6.10.5.2 Set-time
Use the set-time command to set the system date and time. The time entered should
be accurate for the time zone configured for the system. The system will convert the
local time to UTC before saving to the system clock which is always set to UTC. If
SNTP or NTP is enabled (no shutdown), this command cannot be used. The set-
time command does not take into account any daylight saving offset if defined.
CLI Syntax: admin
set-time date time
Example: admin# set-time 2010/09/24 14:10:00
The following example displays the set-time command results.
ALU-1# admin set-time 2010/09/24 14:10:00
ALU-1# show time
Fri Sept 24 14:10:25 UTC 2010
ALU-1#
6.10.5.3 Display-config
The display-config command displays the system’s running configuration.
CLI Syntax: admin
display-config [detail] [index]
Example: admin# display-config detail
The following example displays a portion of the display-config detail command
results.
ALU-1>admin# display-config detail
# TiMOS-B-0.0.current both/i386 NOKIA SAR 7705
# Copyright (c) 2016 Nokia.
# All rights reserved. All use subject to applicable license agreements.
# Built on Fri Sept 24 01:32:43 EDT 2016 by csabuild in /rel0.0/I270/panos/main
# Generated FRI SEPT 24 14:48:31 2016 UTC
exit all
configure
To Next Page
Loading...
