System Management
298
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
6.10.5.4 Tech-support
The tech-support command creates a system core dump.
6.10.5.5 Save
The save command saves the running configuration to a configuration file. When the
debug-save parameter is specified, debug configurations are saved in the config file.
If this parameter is not specified, debug configurations are not saved between
reboots.
CLI Syntax: admin
save [file-url] [detail] [index]
debug-save [file-url]
Example: admin# save ftp://test:test@192.168.x.xx/./1.cfg
admin# debug-save debugsave.txt
The following example displays the save command results.
ALU-1>admin# save ftp://test:test@192.168.x.xx/./1x.cfg
Writing file to ftp://test:test@192.168.x.xx/./1x.cfg
Saving configuration ...Completed.
ALU-1>admin# debug-save ftp://test:test@192.168.x.xx/./debugsave.txt
Writing file to ftp://julie:julie@192.168.x.xx/./debugsave.txt
Saving debug configuration .....Completed.
6.10.5.6 Reboot
The reboot command reboots the router, including redundant CSMs in redundant
systems. If the now option is not specified, you are prompted to confirm the reboot
operation. The reboot upgrade command forces an upgrade of the boot ROM and
a reboot.
CLI Syntax: admin
reboot [active | standby] | [upgrade] [now]
Example: admin# reboot now
Note: This command should only be used with explicit authorization and direction from the
Nokia Technical Assistance Center (TAC).
To Next Page
Loading...
