System Management
216
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
When configuring the system to perform this synchronization, the following occurs:
1. The BOF used during system initialization is copied to the same compact flash
on the standby CSM (in redundant systems).
Note: The synchronization parameters on the standby CSM are preserved.
2. The primary, secondary, and tertiary images (provided they are locally stored on
the active CSM) are copied to the same compact flash on the standby CSM.
3. The primary, secondary, and tertiary configuration files (provided they are locally
stored on the active CSM) are copied to the same compact flash on the standby
CSM.
6.3.5.2 Config Option
The config option synchronizes configuration files by copying the files specified in
the active CSM BOF file to the same compact flash on the standby CSM.
6.3.6 Manual Synchronization
The admin redundancy synchronize command performs manual CSM
synchronizations. The boot-env parameter synchronizes the BOF, image, and
configuration files in redundant systems. The config parameter synchronizes only
the configuration files in redundant systems.
6.3.6.1 Forcing a Switchover
The force-switchover now command forces an immediate switchover to the
standby CSM card.
If the active and standby CSMs are not synchronized for some reason, users can
manually synchronize the standby CSM by rebooting the standby by issuing the
admin reboot standby command on the active CSM.
To Next Page
Loading...
