Basic System Configuration Guide Boot Options
Edition: 01 3HE 11010 AAAC TQZZA 143
ADP runs in the background to allow continued CLI access for status queries and
troubleshooting. Periodic progress updates are sent to the console and can be
viewed through a connected PC. Additionally, dump commands are available to
display information and detailed logs about ADP during and after running on the
system. The logs are not retained over a chassis reboot.
ADP runs only once on a router during initial startup if the automatic discovery is
successful. The learned network interface configuration is retained in the local
database. On subsequent reboots, the router uses its local database to reload its
network configuration. After ADP successfully completes, or if it is manually
terminated, the system sends a command to the BOF to remove the ADP keyword.
You can terminate ADP at any time while it is running by using the CLI or the ACO/LT
button.
Any temporary configuration done by ADP is not stored; however, network
configuration and remote access remain enabled to allow the router to be manually
provisioned remotely. ADP does not run again on future system reboots unless it is
re-enabled via the CLI. If a standby CSM with ADP enabled is inserted into a running
system that does not have the ADP keyword in its BOF file, the ADP keyword is
automatically removed from the inactive card’s BOF file during reconcile.
Note: The ACO/LT button is not available on the 7705 SAR-A, 7705 SAR-Ax, 7705 SAR-W,
or 7705 SAR-Wx.
To Next Page
Loading...
