Nokia 7705 - Page 274

System Management
274
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
6.10.1.1.3 Location
Use the location command to specify the system location of the device. For
example, enter the city, building address, floor, and room number where the router
is located.
Use the following CLI syntax to configure the location:
CLI Syntax: config>system
location location
Example: config>system# location “Bldg.1-floor 2-Room 201”
6.10.1.1.4 CLLI Code
The Common Language Location Code (CLLI code) is an 11-character standardized
geographic identifier that is used to uniquely identify the geographic location of a
7705 SAR.
Use the following CLI command syntax to define the CLLI code:
CLI Syntax: config>system
clli-code clli-code
Example: config>system# clli-code abcdefg1234
6.10.1.1.5 Coordinates
Use the optional coordinates command to specify the GNSS location of the device.
If the string contains spaces, the entire string must be enclosed within double quotes.
Use the following CLI syntax to configure the location:
CLI Syntax: config>system
coordinates coordinates
Example: config>system# coordinates "N 45 58 23, W 34 56 12"
The following example displays the configuration output of the general system
commands:
ALU-1>config>system# info
#------------------------------------------
echo "System Configuration"