Nokia 7705 - Page 282

System Management
282
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
mda-timestamp
Example: config>system>time>ntp# mda-timestamp
config>system>time>ntp# no shutdown
The following example shows enhanced NTP performance enabled using the mda-
timestamp command.
A:ALU-1>config>system>time>ntp# info
----------------------------------------------
shutdown
no authentication-key 1
mda-timestamp
----------------------------------------------
A:ALU-1>config>system>time>ntp#
Multicastclient
This command is used to configure an address to receive multicast NTP messages
on the CSM Management port. The no form of this command removes the multicast
client.
If multicastclient is not configured, all NTP multicast traffic will be ignored.
CLI Syntax: config>system>time>ntp
multicastclient [authenticate]
Example: config>system>time>ntp# multicastclient authenticate
config>system>time>ntp# no shutdown
The following example shows NTP enabled with the multicastclient command
configured.
ALU-1>config>system>time# info
----------------------------------------------
server 192.168.15.221
multicastclient
no shutdown
----------------------------------------------
ALU-1>config>system>time##
Server
The server command is used when the node should operate in client mode with the
NTP server specified in the address field. Use the no form of this command to
remove the server with the specified address from the configuration.