System Management
332
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
contact
Syntax contact contact-name
no contact
Context config>system
Description This command creates a text string that identifies the contact name for the device.
Only one contact can be configured. If multiple contacts are configured, the last one entered
will overwrite the previous entry.
The no form of the command reverts to the default.
Default n/a — no contact name is configured
Parameters contact-name — the contact name character string. Allowed values are any string up to
80 characters long composed of printable, 7-bit ASCII characters. If the string
contains spaces, the entire string must be enclosed within double quotes.
coordinates
Syntax coordinates coordinates
no coordinates
Context config>system
Description This command creates a text string that identifies the system coordinates for the device
location. For example, the command coordinates “37.390 -122.0550” is read as latitude
37.390 north and longitude 122.0550 west.
Only one set of coordinates can be configured. If multiple coordinates are configured, the last
one entered overwrites the previous entry.
The no form of the command reverts to the default value.
Default n/a — no coordinates are configured
Parameters coordinates — the coordinates describing the device location character string. Allowed
values are any string up to 80 characters long composed of printable, 7-bit ASCII
characters. If the string contains spaces, the entire string must be enclosed within
double quotes. If the coordinates are subsequently used by an algorithm that locates
the exact position of this node, then the string must match the requirements of the
algorithm.
To Next Page
Loading...
