System Management
358
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
server
Syntax server ip address [version version] [key-id key-id] [prefer]
no server ip-address
Context config>system>time>ntp
Description This command is used when the node should operate in client mode with the NTP server
specified in the address field of this command. Only the IP address parameter is required; the
other parameters are optional. The no form of this command removes the server with the
specified address from the configuration.
Up to five NTP servers can be configured.
Parameters ip-address — configures the IP address of a node that acts as an NTP server to this
network element.
Values ipv4-address: a.b.c.d
ipv6-address: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x [0 — FFFF]H
d [0 — 255]D
version — the NTP version number that is expected by this node.
Values 2 to 4
Default 4
key-id — the key ID that identifies the configured authentication key and authentication
type used by this node to transmit NTP packets to an NTP server. If an NTP packet
is received by this node, the authentication key-id, type, and key value must be valid;
otherwise, the packet will be rejected and an event/trap generated.
Values 1 to 255
prefer — when configuring more than one server, one remote system can be configured
as the preferred server. When a second server is configured as preferred, then the
new entry overrides the old entry.
ptp
Syntax ptp
Context config>system>time
Description This command enables the context to create or modify ptp parameters for time.
To Next Page
Loading...
