Basic System Configuration Guide System Management
Edition: 01 3HE 11010 AAAC TQZZA 397
peer
Syntax peer peer-id
Context config>system>ptp>clock>ptp-port
Description This command enables the context to configure parameters associated with remote PTP
peers such as grand master clocks.
For ordinary slave clocks, 2 peers are automatically created. For ordinary master clocks, 50
peers are automatically created. For boundary clocks, 1 peer per PTP port is automatically
created.
The no form of the command removes the IP address from the PTP peer.
Default n/a
Parameters peer-id — specifies the PTP peer ID
Values 1 to 50
ip-address
Syntax ip-address ip-address
no ip-address
Context config>system>ptp>clock>ptp-port>peer
Description This command configures a remote PTP peer address and enables the context to configure
parameters for the remote PTP peer.
Up to two remote PTP peers may be configured on a PTP port.
The no form of the command removes the IP address from the PTP peer.
Default n/a
Parameters ip-address — specifies the IPv4 address of the remote peer
Values a.b.c.d
unicast-negotiate
Syntax [no] unicast-negotiate
Context config>system>ptp>clock>ptp-port
Description This command specifies whether the slave clock is to initiate a unicast request to the master
clock or wait for announce and synchronization messages from the master clock.
To Next Page
Loading...
