System Management
410
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
description
Syntax description description-string
no description
Context config>redundancy>multi-chassis>peer
Description This command configures a text description and associates it with a configuration context to
help identify the content in a configuration file.
The no form of the command removes the string from the configuration.
Default n/a
Parameters description-string — specifies the text description
Values any string of 7-bit ASCII characters, up to 80 characters in length;
the entire string must be enclosed in double quotes if it contains any
special characters
mc-lag
Syntax [no] mc-lag
Context config>redundancy>multi-chassis>peer
Description This command enables the context to configure multi-chassis LAG parameters.
The no form of this command administratively disables multi-chassis LAG. The no mc-lag
command can only be issued only when MC-LAG is shut down.
Default n/a
hold-on-neighbor-failure
Syntax hold-on-neighbor-failure multiplier
no hold-on-neighbor-failure
Context config>redundancy>multi-chassis>peer>mc-lag
Description Sets the number of keep alive intervals the standby 7705 SAR will wait for packets from the
active node before assuming a redundant neighbor node failure. This delay in switchover
operation is required to accommodate different factors influencing node failure detection rate,
such as IGP convergence or high availability switchover times, and to prevent the standby
node from take over prematurely.
The no form of the command sets this parameter to its default value.
Default 3
To Next Page
Loading...
