CLI Usage
80
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
Parameters router-instance — specifies the router name or service ID
Values router-name: Base, management
service-id: 1 to 2147483647
Default Base
service-name — specifies the service name, 64 characters maximum
session
Syntax session ldp-id [ldp-id...(up to 5 max)] [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>router>ldp
Description This command displays statistical information for LDP sessions at the configured interval until
the configured count is reached.
The first screen displays the current statistics related to the specified LDP sessions. The
subsequent statistical information listed for each interval is displayed as a delta to the
previous screen output.
When the keyword rate is specified, the rate per second for each statistic is displayed instead
of the delta.
Monitor commands are similar to show commands, but only statistical information is
displayed. Monitor commands display the selected statistics according to the configured
number of times at the interval specified.
Parameters ldp-id — specifies the IP address of the LDP session to display
Values ip-addr[:label-space]
ip-addr — a.b.c.d
label-space — [0 to 65535]
seconds — configures the interval for each display in seconds
Values 3 to 60
Default 10
repeat — configures how many times the command is repeated
Values 1 to 999
Default 10
absolute — displays raw statistics, without processing. No calculations are performed
on the delta or rate statistics.
rate — displays the rate per second for each statistic instead of the delta
Output The following output is an example of statistical information for the LDP session.
To Next Page
Loading...
