Basic System Configuration Guide CLI Usage
Edition: 01 3HE 11010 AAAC TQZZA 83
Address 0 0
Address Withdraw 0 0
-------------------------------------------------------------------------------
At time t = 9 sec (Mode: Rate)
-------------------------------------------------------------------------------
FECs 0 0
Hello 0 0
Keepalive 0 0
Init 0 0
Label Mapping 0 0
Label Request 0 0
Label Release 0 0
Label Withdraw 0 0
Label Abort 0 0
Notification 0 0
Address 0 0
Address Withdraw 0 0
===============================================================================
ALU-12>monitor>router>ldp#
statistics
Syntax statistics [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>router>ldp
Description This command displays statistics for an LDP instance at the configured interval until the
configured count is reached.
The first screen displays the current statistics related to the LDP statistics. The subsequent
statistical information listed for each interval is displayed as a delta to the previous screen
output.
When the keyword rate is specified, the rate per second for each statistic is displayed instead
of the delta.
Monitor commands are similar to show commands, but only statistical information is
displayed. Monitor commands display the selected statistics according to the configured
number of times at the interval specified.
Parameters seconds — configures the interval for each display in seconds
Values 3 to 60
Default 10
repeat — configures how many times the command is repeated
Values 1 to 999
Default 10
absolute — displays raw statistics, without processing. No calculations are performed
on the delta or rate statistics.
rate — displays the rate per second for each statistic instead of the delta
To Next Page
