CLI Usage
92
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
 
sap-aggregation-group
Syntax sap-aggregation-group group-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>service>id
Description This command displays the statistics for the specified SAP aggregation group that is 
associated with the service.
Parameters group-id — specifies the identifier for the SAP aggregation group
Values  1 to 32 characters
seconds — configures the interval for each display in seconds 
Values 11 to 60 
Default 11  
repeat — configures how many times the command is repeated 
Values 1 to 999 
Default 10 
absolute — displays the absolute rate-per-second value for each statistic 
rate — displays the rate per second for each statistic instead of the delta 
Output The following output is an example of statistics for a SAP aggregation group.
Output Example
*A:SYS28# monitor service id 1570 sap-aggregation-group SAG repeat 2
===============================================================================
Monitor statistics for Service 1570 SAP Aggregation Group SAG
===============================================================================
-------------------------------------------------------------------------------
At time t = 0 sec (Base Statistics)
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
Sap Aggregation Group Statistics
-------------------------------------------------------------------------------
Last Cleared Time : N/A
Dropped Egress Cells (unconfigured vpi/vci): 14
Packets Octets
Forwarding Engine Stats
Dropped : 0 n/a
Off. HiPrio : 205557 n/a
Off. LowPrio : n/a n/a
Queueing Stats(Ingress QoS Policy 1)
Dro. HiPrio : 0 n/a
Dro. LowPrio : n/a n/a
For. InProf : 0 0
For. OutProf : 205557 68605598