Nortel 2245 - Page 141

Troubleshooting Page 141 of 206
WLAN IP Telephony Installation and Configuration
Initializing … The wireless handset is
performing a power-on
initialization.
None. This is informational only.
Internal Err. # # The wireless handset has
detected a fault from which it
cannot recover.
Record the error code so it can
be reported. Turn the wireless
handset off, then on again. If
error persists, try registering a
different wireless handset to this
telephone port. If error still
persists, contact Nortel
Networks Technical Support and
report the error.
Multiple GW The wireless handset is
attempting to communicate with
two WLAN IP Telephony
Managers 2245.
Check the WLAN IP Telephony
Managers 2245 configuration.
More than one master may be
configured.
Network Busy All APs are full or busy. Try call again later.
No Func. Code Download error. Wireless
handset unable to find software
to download.
Correct the configuration to
enable the wireless handset to
find the software on the TFTP
Server.
No Host IP The wireless handset is
configured for “static IP” (as
opposed to “use DHCP”) and no
valid host IP address (the
wireless handset’s IP address)
has been entered.
Enter a valid IP address in the
configuration settings or change
to “use DHCP”.
No IP Address Invalid IP address. Check the IP address of the
wireless handset and
reconfigure if required.
Table 19
Wireless handset status messages (Part 6 of 11)
Message Description Action