Troubleshooting Page 151 of 206
WLAN IP Telephony Installation and Configuration
isetCount / isetGet
Use the alias IP address of the WLAN Handsets 2210/2211 in the expression
string of the isetCount and isetGet commands, not the physical IP address.
The following is an example of the isetGet output for the WLAN
Handset 2211.
->isetGet "IP == 192.168.10.200"
IP Address Type RegType State Up Time Set-TN Regd-TN HWID FWVsn
---------- ----- ------- ----- ------- ------- ----- ------------ ---------
192.168.10.200 i2004 Regular online 0 00:12:00 062-02 062-02 3000907a017e476607 097.021
UNIStimVsn SrcPort DstPort
--------- ------ ------
2.6 5100 5000
isetReset / isetResetAll
The isetReset command can be used to reset the wireless handsets by
specifying the wireless handset alias IP, not the physical IP address:
-> isetReset “192.168.10.200”
value = 0 = 0x0
isetShow / isetShowByTN / isetShowByIP
Similar to the dsetShow command, the wireless handset outputs its specific
hardware ID (see dsetShow) and alias IP, not the physical IP address. The
F/W version has a different format <Version>.<Issue> in this output.
To Next Page
Loading...
