Oberheim Matrix-12 - Assign Single Patches to the Voices

• An Edit Indicator dot will be displayed next to each Patch
number showing that the Voices' Patches have been altered by
the initializing process of the Basic Patch.
• The MULTI PATCH Mode TRANS Page will be recalled and
displayed in the PAGE MODIFIER displays.
The Basic MULTI Patch defaults to the following conditions:
• All Voices are assigned to ZONE 1.
• All of the ZONEs1 Page 1 parameters default to:
MODE LIMITS CHANNEL
ROTATE 0 TO 127 OMNI
• ZONE 1 Page 2 defaults to all parameters enabled.
ZONEs 2 through 6 default to MIDI IN. VOICE ROB and
KEYBOARD enabled, MIDI OUTand CONTROLLERS
are disabled.
• TRANS defaults all Voices to -12 (one Octave down).
• PAN defaults all Voices to MID.
• VOLUME defaults all Voices to +63.
• VIB Page 1 defaults to:
SPEED WAVE AMP
56 TRIANGLE 0
VIB Page 2 defaults to:
LAG
(off)
SPEED = OFF 0 I AMP = LEV 2 +63
• DETUNE defaults all Voices to 0(no detune).
STEP 2: Assign SINGLE Patches to the Voices
Press the VOICES 1-6/VOICES 7-12 button so that VOICES 1-6 are
displayed.
Press all six PATCH EDIT buttons so that all six SINGLE Patch numbers
in the PROGRAMMER display become underlined.
Matrix-12 Owner's Manual 163