Oberheim Matrix-12 User Manual

ALL This parameter loads the M ATRIX-12fs memory with the data
on the tape. Please bear in mind that the load ALL
function will erase all of the memory in the
synthesizer and replace it with the data coming
from the tape.
The procedure for loading ALL is identical to that for
CHECK CASS. The only extra step is to make sure that
MEMORY PROTECT on the back panel is turned OFF. If it is left
ON, LOAD ALL cannot take place.
Selective Loading from Tape
ONE This parameter allows you to take one SINGLE Patch or one
MULTI Patch from the tape and load it individually into the
MATRIX-12. This feature permits the loading of individual
Patches from several tapes in order to compile them into one
bank of memory.
1. Turn off MEMORY PROTECT on the back panel.
2. When the ONEparameter is entered, the display will read:
LOAD FROM CASSETTE INTO MATRIX-12
SINGLE = XX -> XX START
or
MULTI = XX -> XX START
Knob #1 is used to select between SINGLE Patches and
MULTI Patches.
3. The first XX display selects the Number of the Patch on the
tape that you want to load in. This is referred to as the
HsourceH Patch and is selected with the X SELECT buttons (if
underlined! or by Knob #2.
The second XXdisplay selects the Number of the Patch in
the MATRIX-12 that you want the source Patch to go. This
is referred to as the "destination" Patch and is selected with
the X SELECT buttons (if underlined! or by Knob #3.
Remember that the Patch currently stored in this memory
location will be erased and replaced with the Patch
coming in from tape.
Rewind the tape to the point where the data's leader tone
just begins. In this process, we will play the entire bank of
data from the tape. The MATRIX-12, being set up to load in
just a single Patch, will pick the selected Patch only and
ignore the rest of the data on the tape.
76 Matrix-12 Owner's Manual

Oberheim Matrix-12 Specifications

General

Brand	Oberheim
Model	Matrix-12
Category	Synthesizer
Language	English