Oberheim Matrix-12 - MIDI Page Settings

CLEAR can also be used to reset all of the Global pararmeters in SINGLE
PATCH Mode. If you have been experimenting in SINGLE PATCH Mode,
remember that these settings are not programmable per Patch and will
affect all SINGLE Patches Globally. Also, these settings will remain as they
are until you change them, even if the MATRIX-12 is powered off.
1. TurntheMATRIX-12off.
2. Press and hold the CLEAR button.
3. While you are holding CLEAR, turn the M ATRIX-12 back on.
4. The displays in the PAGE MODIFIER section of the front panel will read:
RESET MEMORY ? (DOESN'T AFFECT PATCHES)
YES no
5. Press the YES button and the MATRIX-12 will select SINGLE Patch 00
with the OBERHEIMQas'ic Patch recalled and the Global parameters
will default to the following settings:
Matrix-12 Owner's Manual
45