Oberheim Matrix-12 - Copying Patches; Basic Patch

2. Copying Patches
You are able to copy a SINGLE Patch from one location to another:
1. Select the Patch Number of the Patch that you want to copy. This is the
"source" Patch.
2. Press and hold STORE.
3. While holding STORE, type in the 2-digit number of the "destination"
patch - the new Patch where you want the source Patch to go. The
Patch originally in this location will be replaced by the source Patch.
You are able to copy a MULTI Patch from one location to another. Enter
MULTI PATCH Mode and follow the steps listed above for copying SINGLE
Patches.
The STORE button can also be used in the selection of different Patches
(copying Patches) per Voice in MULTI PATCH Mode, dicussed in the
previous section on the PATCH EDIT buttons:
1. When the MATRIX-12 is in MULTI PATCH Mode, press the PATCH
EDIT button beneath the Voice you want to copy, so that its current
Patch Number becomes underlined. This is the "source" Voice.
2. Select the Patch you want this Voice to play by entering its 2-digit
SINGLE Patch Number from the Keypad. If this Voice already contains
the Patch you want, you can skip this step.
3. Press and hold STORE. The Voice you selected will have its Patch
Number replaced with" **M as long as you are holding STORE.
4. While holding down STORE, press the PATCH EDIT button of any
Voice and its Patch Number will be replaced with the one currently
contained in the "source" Voice.
5. You may even switch Voice Banks, if necessary. Continue to hold
STORE, press the VOICES 1 -6 / VOICES 7-12 key and select as many
Voices as needed.
When you have finished editing the MULTI Patch, you must STORE the
edited version if you intend to keep it.
3. The OBERHEiM "Basic Patch"
Although we will cover this is more detail in Part 3, the MATRIX-12
contains in its permanent memory a "Basic Patch" that is used to create
new Patches "from scratch". A very simple, straight-forward Patch that
makes for an ideal starting point in creating your own original Patches, the
BASIC PATCH can be called up from memory any time that the MATRIX-12.
is in SINGLE PATCH Mode.
1. Select a Patch Number of a patch that you want to replace.
2. Press and hold STORE.
34 Matrix-12 Owner's Manual