Oberheim Matrix-12 - Patch;Voice Copy; To Copy a Patch from One Voice Bank to Another

4. You are, however, still able to compare the entire edited MULTI
Patch with its original version and you can still STORE the SINGLE
Patches one at a time.
5. Patch/Voice Copy
You can also copy a SINGLE Patch from one Voice to another within a
MULTI Patch. The STORE button is used in the selection of different
Patches per Voice in MULTI PATCH Mode:
To copy a Patch from one Voice to another within the same Voice Bank:
1. When the MATRIX-12 is is MULTI PATCH Mode, press the PATCH
EDIT button beneath the Voice you want to copy, so that its current
Patch Number becomes underlined. This is the "source" Voice.
2. Select the Patch you want this Voice to play by entering its 2-digit
Patch Number from the Keypad. If this Voice already contains the
Patch you want, you can skip this step.
3. Press and hold STORE. The Voice you selected will have its Patch
Number replaced withM **M as long as you are holding STORE.
4. While holding down STORE, press the PATCH EDIT button of any
Voice. This is the "destination" Voice. Its Patch Number will be
replaced with the one currently contained in the "source" Voice.
5. You may even switch Voice Banks, if necessary. Continue to hold
STORE, press the VOICES 1 -6/VOICES 7-12 key and select as
many Voices in the other Bank as needed. See the discussion
below.
To copy a Patch from one Voice Bank to another:
1. Press the PATCH EDIT button of the Voice with the Patch that you
want to copy, so that it becomes underlined. Again, this is the "source"
Patch.
2. Press and hold STORE.
3. While holding STORE, press the VOICES 1-6/VOICES 7-12 button
and switch to the other Voice Bank.
4. Still holding STORE, press the PATCH EDIT button of the
"destination" Voice - the Voice that you want the selected patch to go.
The Patch originally in this Voice location will be replaced by the source
Patch.
32 Matrix-12 Owner's Manual